DIMENSIONS AND MOUNTING INFORMATION
1598 DIMENSIONS AND MOUNTING INFORMATION
The Micropolis 1598 drive uses industry-standard mounting for 5 1/4-inch "full-height" Winchester
Recommended orientation is vertical on either side, or horizontal with the Device Electronics board down; other mounting orientations may be used provided the ambient air temperature around the drive is kept at or below 50° C (122° F).
The term "ambient" becomes imprecise when referencing a drive in a system, since it is difficult to determine where the air temperature should be measured. To help resolve this confusion, Micropolis specifies that the maximum HDA casting temperature (regardless of the air temperature around the drive) is 60° C (140° F). Not exceeding this temperature will ensure that the head-to-media interface never exceeds its temperature limit.
Since the drive acts as a heat sink to dissipate heat from the unit, the enclosure and mounting structure should be designed to allow natural convection of heat around the HDA and frame. If the enclosure is small or natural convection is limited, a fan may be required.
The figure below shows the mounting hole locations.
The mounting screws must be selected so that they do not penetrate the bottom mounting holes by more than 0.20 inches or the side mounting holes by more than 0.156 inches. Screws that are too long will short to PCBA components and/or prevent proper operation of the shock mount system.