Micropolis 2200A-Series

DIMENSIONS AND MOUNTING INFORMATION

2205A/2210A/2217A DIMENSIONS AND MOUNTING INFORMATION

The Micropolis 2205A, 2210A, and 2217A drives use industry-standard mounting for 3 1/2-inch "full-height" Winchester disk drives. They are designed such that the outer frame should be hard-mounted to the host equipment; no additional or external shock mounts should be used.

Recommended orientation is vertical on either side, or horizontal with the Device Electronics board down; other mounting orientations may be used.

No matter what mounting orientation is used, Micropolis specifies that the maximum HDA casting temperature not exceed 60° C (140° F).

Caution

Mounting screws must not penetrate the bottom mounting holes by more than 0.20 inches, or the side mounting holes by more than 0.156 inches. Screws that are too long may short-circuit PCBA components and/or prevent proper operation of the shock mount system and may damage the HDA.